AutoPot 16 mm Mainline to 6 mm & 9 mm Tee and Cross Connectors

AutoPot mainline reducer tees and cross connectors are designed for branching a larger irrigation supply pipe into the smaller lines used with compatible AutoPot watering systems. The range covers fittings for older 6 mm tubing and the newer 9 mm AQUAvalve5 pipe arrangement, helping growers maintain and extend the correct generation of equipment.

Choose an AutoPot connection

• 16 mm to 6 mm tee: a single branch for older AutoPot systems with 6 mm pipe.
• 16 mm to 9 mm tee: a single branch for compatible AQUAvalve5 setups using 9 mm pipe.
• 16 mm to two 9 mm outlets (cross connector): takes two 9 mm branches from a 16 mm main feed.

Important pipe-size guidance

AutoPot describes its larger mainline pipe as 16 mm outside diameter, approximately 13 mm inside diameter. The named 6 mm and 9 mm branch connections belong to different generations of AutoPot components and should not be interchanged. Check the measured pipe diameter and AQUAvalve version before ordering, and use suitable pipe-retaining clips where recommended.

Installation

Cut pipe squarely, push it fully onto the correct connector and test the assembled water supply for leaks before unattended operation. Choose a branch fitting appropriate for the reservoir feed and number of attached watering modules.

What's included?

One genuine AutoPot connection fitting of the selected type. Pipe, AQUAvalves and other system components are sold separately.